Am I supposed to oil the seal on the oil filter before I put it on?

I change my oil at home and I was told that you are supposed to oil the seal on the filter before you tighten it on to ensure a proper seal. Is this true?Am I supposed to oil the seal on the oil filter before I put it on?
Yes, you should. I just dip my finger into a bottle of oil and then run it around the seal until the seal is coated. It is also a good idea to fill your new oil filter about half full with new oil before you install it. This helps get the oil moving through your car's oiling system.Am I supposed to oil the seal on the oil filter before I put it on?
Yes, if you rub a light coating of oil on the seal it will allow it to slide better when you tighten it. This will prevent the seal from grabing and kinking and possibly causing a leak.





Even using a little of the old oil will work since you will have that handy under the car when putting the new filter on.
Yes, you should apply a light coat of oil to the seal. I also fill the oil filter half way when applicable, before installing it. This is not possible with filters that mount upside down. But you can put a little oil in the filter even if it mounts side ways. It helps a bit against dry starts after changing the oil.
Yes. Just put a little oil on your finger and run it around the seal. That will ensure the rubber doesn't bind anywhere as its being tightened, causing it to leak. Besure and visually inspect for leaks after you pressure up the system the first time.
yep that,s true and another thing you can do if you can and that,s fill the oil filter before installing it. that helps the oil pump out when you first start it.
well it only helps when it comes time to remove it but you dont have to do it and you never over tighten them just use one hand is all you need oil it or not doesnt matter but ive alway have never hurts to do it like everyone else
Yes that is true. This will prevent problems with getting the filter off the next time you change the oil.
if you don't you'll have a bit of a problem getting the filter off next time you change the oil.
You better. If you want to get the oil filter off next time.





People are not aware of how much pressure an engine creates.





You will find out if you don't
yes a shall amount of oil just with your finger tip also it should be clean oil not dirty oil
Just put a very light coating of fresh oil on the casket and you'll be ok.
Yes, Clean oil only!!
yes, or what works better is a light coat of wheel bearing grease.